How to clean a work truck with a pressure washer, you will need a Water Cannon pressure washer with appropriate attachments, a mild detergent, and possibly some additional tools such as a brush or rotating nozzle. Here are the general steps to follow:
- Park the work truck in a shaded area, out of direct sunlight, to prevent the cleaning solution from drying too quickly.
- Begin by rinsing the entire surface of the truck with a low pressure spray to remove loose dirt and debris.
- Mix a mild detergent with water in a bucket, following the manufacturer's instructions.
- Using the soap injector with the low pressure spray 65 degree (black) nozzle, apply the detergent solution to the truck, working from the top down. Be sure to pay special attention to any areas that are particularly dirty or affected by road film.
- Allow the detergent to sit on the truck for a few minutes, as per the instruction of detergent usage.
- Using a high pressure spray and a wide fan nozzle 25 (green) or 40 (white) degree most popular, power wash the truck to remove the detergent and dirt.
- Rinse the work truck thoroughly with high pressure clean water to remove any remaining detergent or dirt. Some stubborn road film may require a follow up cleaning with soft brush
8. Dry the truck with a clean microfiber towel or chamois to prevent water spots.
Note: Make sure the nozzle of pressure washer is not too close to the vehicle, this might cause paint damage It is always better to test pressure setting in inconspicuous area before starting the process.
Watercannon.com has an entire category dedicated to truck and car wash applications.
.gif)
0 comments :
Post a Comment