Hot Boxes

 Hot boxes do not have a starter or engine. 

The power supply is 120 volt plug in the wall

Or

12 volt with a battery that charges itself from the diesel burner and 

converts to 12 volt as a power source.

Phone: 833.400.0774

Read More

How to clean a truck with a pressure washer, you will need a pressure…

 

How to clean a work truck with a pressure washer, you will need a Water Cannon pressure washer with appropriate attachments, a mild detergent, and possibly some additional tools such as a brush or rotating nozzle. Here are the general steps to follow:

1. Park the work truck in a shaded area, out of direct sunlight, to prevent the cleaning solution from drying too quickly.
2. Begin by rinsing the entire surface of the truck with a low pressure spray to remove loose dirt and debris.
3. Mix a mild detergent with water in a bucket, following the manufacturer's instructions.
4. Using the soap injector with the low pressure spray 65 degree (black) nozzle, apply the detergent solution to the truck, working from the top down. Be sure to pay special attention to any areas that are particularly dirty or affected by road film.
5. Allow the detergent to sit on the truck for a few minutes, as per the instruction of detergent usage.
6. Using a high pressure spray and a wide fan nozzle 25 (green) or 40 (white) degree most popular, power wash the truck to remove the detergent and dirt.
7. Rinse the work truck thoroughly with high pressure clean water to remove any remaining detergent or dirt. Some stubborn road film may require a follow up cleaning with soft brush 

                  8. Dry the truck with a clean microfiber towel or chamois to prevent water spots.

Note: Make sure the nozzle of pressure washer is not too close to the vehicle, this might cause paint damage It is always better to test pressure setting in inconspicuous area before starting the process.

Watercannon.com has an entire category dedicated to truck and car wash applications.  

Phone: 833.400.0774 

Read More

Is rebuilding a commercial pressure washer difficult?

Rebuilding a commercial pressure washer can be a complex task that requires a certain level of technical knowledge and skill.

 Depending on the specific make and model of the pressure washer, as well as the extent of the repairs needed, rebuilding the machine can be a relatively simple process or a more challenging one.

If the pressure washer is relatively new and only requires simple repairs, such as replacing a worn out pump or nozzle, then rebuilding it may be relatively straightforward. In this case, it may be possible to do the repairs yourself, provided you have the necessary tools and experience.

However, if the pressure washer is older or requires more extensive repairs, such as replacing the heating elements or overhauling the pump, then rebuilding it can be more difficult. In this case, it may be best to hire a professional technician with experience in rebuilding commercial pressure washers.

It's also important to consider the cost of rebuilding a commercial pressure washer. So it's important to weigh the cost and benefits of rebuilding a pressure washer before proceeding.
In summary, rebuilding a commercial pressure washer can be difficult, depending on the machine's make and model, the extent of the repairs needed, and the tools and expertise you have. It is important to consider the cost and benefits of rebuilding a pressure washer before proceeding.

Please check out Water Cannon’s vast selection of replacement pump packages. 

Water Cannon provides free phone technical support. 
free phone technical support. 800.333.9274

Read More